|
H&R .38 Top Break Lg.Frame (99f)
|
|
|
Quantity in Basket:
None
Code: HR_99f
Price: $68.00
Shipping Weight: 0.15 pounds
|
|
This grip is for some of the models of Harrington &
Richardson .38 S&W caliber break top revolvers with a
large frame. But H&R, like other manufacturers, used barrels
and cylinders from stock inventory to finish building guns
that were being updated or replaced with improved models, so
sometimes a frame normally used for one caliber may be
found in a gun with another caliber. Also, the company might
introduce a model in one caliber, and later add others to
the same frame size.
Therefore, although this grip was modeled from an original
found on a .38 S&W large frame, your .32 S&W or even perhaps
a .22 rimfire might possibly use the same size of frame.
The only way to know for sure is to (a) compare measurements
listed here, and/or (b) make a pencil tracing around your
existing grips on a 3 x 5 index card, and mail the card
to me. (Mark the screw hole location and your order
number on the card.)
If you have a gun without a grip or with ill-fitting grips,
make a 3 x 5 index card stock template to fit your gun
frame. Cut it out with scissors and trim it to match the
gun like a grip. If you cut a bit too much, just tape a
piece back on and trim again: looks don't matter, only the
outline counts. I can use your template to hold to the
backside of a grip and see if the grip is at least that
large with the same shape. If so, you can fit the grip
to your gun without much work.
- Overall height (B) = 2.28 inches
- Width across top (A) = 0.836 inches
- Width across base (C) = 0.9615 inches
- Height of front "ear" from base (D) = 1.75 inches
- Width of rear step (I) = 0.1125 inches
- Width of front step (H) = 0.160 inches
- Height of dome top above line joining ears = 0.25 inches
- Width across the neck = 0.848 inches
- Width across screw hole center = 1.08 inches
- Screw hole center to rear edge (G) = 0.524 inches
- Height of screw hole (F) = 0.9085 inches
This grip is quite similar to several other H&R grips and
is listed because the production changes and tolerances in
various guns over the years might mean it fits one version
of the same model better than one of the other listed grips
for that model. The tracing you send will pin it down to
the right grip.
|
Related Item(s)
Code
|
Name
|
Price
|
Availability
|
|
HR_59d
|
H&R T.B. lg. frame smooth (59d)
|
$68.00
|
|
HR_140b
|
H&R T.B. lg.frame checkered (140b)
|
$68.00
|
|
HR_1c
|
H&R Generic Top Break (1c)
|
$68.00
|
|
HR_113c
|
H&R 38 Top Break Smooth (113c)
|
$68.00
|
|
HR_107f
|
H&R Lg.Frame TB, factory (107F)
|
$68.00
|
|
HR_97c
|
H&R 1904 Solid Frame Smooth
|
$68.00
|
|
|