|
Colt Generic 3-pc SA Larger (57a)
|
|
|
Quantity in Basket:
None
Code: Colt_57a
Price: $68.00
Shipping Weight: 0.20 pounds
|
|
This is a GENERIC, large size single action grip kit.
I made TWO of this type of grip. This one is LARGER
than the sister grip featured in another listing.
This is a "kit" of two grip panels and a spacer. I call
it a "3-piece grip" but you will assemble it into a
"1-piece grip" after sanding to fit your frame.
You can also choose to order it as a 2-panel, screw-mount
set. If you don't send a template or tracing with the
location of the screw hole indicated, then all I can do
is mount the screw where it normally goes on a
Colt Single Action Army 1873 Peacemaker. Or I can send
the screw unmounted, and let you make the hole, if
you prefer. Just give me a note, above, to that effect if
that's your desire.
This grip has been tested to have enough material to fit
the following weapons frames, in at least SOME clones:
- 1848 Baby Dragoon
- 1860 Army Standard Frame (NOT THE LONG FRAME)
- 1861 Colt Army
- 1851 Colt Navy
- Colt Uberti
- EMF Dakota Colt
- COLT Cimarron (not the P 36 model, or the clone)
- Colt SA Army Clone
- Colt Cowboy Clone
- Beretta SAA Clone
- Taylor SAA Clone
- American Arms
- Great Western II
- Cattleman
- Millenium
plus MANY other Uberti and Pietta COLT CLONES that had
a one piece grip.
Look at the actual dimensions of my grip that I have
provided below. Measure your own frame very carefully.
If your dimensions are smaller than the ones I have
provided, these grips can be shaped to fit your firearm.
These grips require shaping and sanding to achieve a
proper fit. They will not just drop on to the back
frame, they have to be custom fitted to your individual
firearm.
If your grip frame is larger, then these grips won't fit.
Simple as that. You can tell much better than I can
because you have the gun and can check the grip
measurements.
My other Colt grips might fit some of the listed guns
better, with less material to sand away at the edges.
This is the big set, made as a catch-all in case none
of the others are quite big enough for your particular
version of the gun (there is a lot of variation in grip
frame sizes for the same model). You can tell by
measuring and comparing. Or send me a pencil tracing around
your grips (not a fax or photocopy, which distorts the
size too much for precise measurement).
The actual dimensions of this grip, referencing the
dimensional photo, are as follows:
- "A" = 15/16"
- "B" = 3 3/8"
- "C" = 2 5/8"
- "D" = 2 1/8"
- 5/8" THICK AT THE BUTT
- 3/8" THICK AT THE HAMMER AREA
|
Related Item(s)
Code
|
Name
|
Price
|
Availability
|
|
Colt_81c
|
Colt Generic 3-pc SA Smaller (81c)
|
$68.00
|
|
|