|
Bond Derringer, Staghorn (21b)
|
|
|
Quantity in Basket:
None
Code: Bond_21B
Price: $75.00
Shipping Weight: 0.15 pounds
|
|
This grip is for the Bond standard size derringer and is
a staghorn pattern. You get two spacers and the mounting
kit installed (No.4 kit) also. The two spacers are fitted
to the frame ID and epoxy glued to the backside of each
grip panel so the grips can't rotate. If you want to make
sure your epoxy glue is sufficiently tough, just drill a
small pin hole, say 3/32 inch or so, through the spacer and
a short distance into the grip back, and install a steel pin
that fits snugly so it needs to be tapped in with a little
hammer. Usually a 1,500 psi standard epoxy is fine if you
clean the surfaces well before applying it.
The reason I don't provide the grip kit with the spacers
attached is so you can properly fit them to your individual
gun for best fit. Using another gun might not take into
account any manufacturing tolerance or changes in the frame
design. Best to fit each grip precisely to your own gun.
It's not hard. Just requires paying attention and not trying
to rush the job.
The grip dimensions are given in reference to letters,
assigned to point on the grip outline.
- Top of the grip, dead center, is called "B".
- The bottom pointy part of the grip is called "A".
So the straight line measurement is taken between
these points, and to the center of the screw hole:
- A to B = 2.3 inches
- A to screw hole center = 0.9 inches
- Widest part of the top = 1.4 inches
- Width of a line through the screw hole center, parallel
to the line across the widest part of the top = 1.3 inches.
This grip is shaped like a fat comma. There are few spots
where you can make a positive measurement and write it down
in a way that informs another person just where that is. But
the above gives you some repeatable points to use.
Note that this grip is secured by a single No.4 mounting
screw with the standard brass ferrule and press fit nut,
unless you specify otherwise. If you tell me NOT to
install this kit, I'll send it in a little bag anyway so
you can change your mind if you wish and install it
yourself.
|
Related Item(s)
Code
|
Name
|
Price
|
Availability
|
|
Bond_80a
|
Bond Derringer (80a)
|
$68.00
|
|
Bond_80e
|
Bond Snake Slayer Oversized (80e)
|
$68.00
|
|
Bond_108c
|
Bond Snake Slayer (108c)
|
$68.00
|
|
Bond_127d
|
Bond Snake Slayer Smooth (127d)
|
$68.00
|
|
Bond_80s
|
Bond Oversize Grip Spacer (80s)
|
$5.00
|
|
|