This smooth grip is for the .32 caliber exposed hammer
Smith & Wesson breaktop style revolvers, but may also fit
some of the solid frame models and possibly some .38
calibers. The only way to be sure of the fit is to send
a pencil tracing around your grips, or heavy paper template that fits your
gun like the grips. Second best is to compare specs with
your grip measurements.
These grips are made just slightly larger than required so
you can sand them a little, for a perfect fit to most of
the variations and tolerances found in the guns.
Grip specs:
(A) Width across top corners = .877 inch
(B) Height from center of top to base = 2.23 inch
(C) Width of flat base area = .875 inch
(D) Height of front corner = 1.814 inch
(E) Height of rear corner = 2.346 inch
(F) Height of screw hole = .926 inch
Width at widest part of base = 1.1 inch
Width across screw hole = 1.08 inch
(H) Front step = .143 inch
(I) Rear step = .184 inch
Height of round top above line between corners = .21 inch
Stock items (medallions, screws, specials) usually ship within 10 days.
I can't promise a specific ship date, as it will vary with circumstances. Depending on the time of year and number of orders pending, average time to finish a grip order is 30 to 90 days. That's average, not a quote. They are all individually made to your specific order.
If you can't wait, please don't order! I'm working as fast as possible.
Be SURE to read the TERMS of SALE page, so you KNOW what you are getting.