|
S&W 38 DA Hand Ejector (13F)
|
|
|
Quantity in Basket:
None
Code: SW_13f
Price: $68.00
Shipping Weight: 0.20 pounds
|
|
This is a copy of an early Smith & Wesson grip set for a
.38 S&W Double Action hand ejector revolver, which is not
the "K" frame size. Check the dimensions and measure your
gun, before you order. Do not order based only on the
name, because the same models may have different size grip
frames. When a new gun was introduced, often there was an
inventory of older parts such as the grip frame which was
used on the new model for a short period of time. Then the new
design of different shape or size was used when the old
inventory was gone. Most gun manufacturers engaged in this
practice when a new model tended to make a similar older
model obsolete. They knew that the investment in parts
would go to waste unless those parts could be incorporated
into the new models for a time, saving a few for repairs
of the originals if they were so inclined.
Send a tracing (see instructions on the main web pages) or
compare measurements and decide for yourself if the grip
you are ordering will fit your particular gun.
Bear in mind that if you don't send a tracing, I have no
way to check the size and shape of your gun. Therefore,
all I can guarantee is the dimensions listed here, not
whether they match your gun. If you want a guarantee
so you can return the grips if they don't fit, send a
tracing as described. If you take good measurements and
compare, you can see if the grips fit your gun or not
before you order.
- Width across top corners (A) = 1.05 inches
- Overall height/height of rear corner (B/E) = 2.9 inches
- Width across base (C) = 1.2 inches
- Front corner to base (D) = 2.3 inches
- Step widths (H/I) = 0.15 inches
- Height of round top above corners = 0.4 inches
- Width across the center of screw hole = 1.4 inches
- Center of screw hole to rear edge = 0.67 inches
- Height of screw hole center from base (F) = 1.15 inches
This grip is formed in a mold made from an old original
wood grip which has a small amount of wear, so it will
look appropriate for the older revolvers. The S&W molded
in logo at the top is visible but light, compared to later
grips. You can select a small (3/8-in or smaller diameter)
medallion from the drop down menu above if you wish.
Here are three sizes of S&W grips of similar design. There are
many more, by the way. The smallest shown is from a .38 S&W
top break "I" frame revolver. The middle grip is the 13F
featured here. The large grip is from a No.3 .44 revolver.
All these grips are of the "round butt" style, which is
half-way between a "Bird's head" and a "Square Butt" in
regard to the amount of curvature of the back and base.
|
Related Item(s)
Code
|
Name
|
Price
|
Availability
|
|
SW_32a
|
S&W 38 Special Hand Ejector, smooth (32a)
|
$68.00
|
|
SW_100c
|
S&W 32 Reg.Police Rnd Butt (100c)
|
$68.00
|
|
SW_141c
|
S&W Generic Grip Blank (141c)
|
$38.00
|
|
|