This is the flat backed set of Ruger panel inserts for the
SP-101 Ruger 22LR 8-shot revolver. The panel backs are flat
and do not require a locating pin hole as they fit down into
the cut-out of the hard rubber grip. If you use these on
other models of guns, the backs may possibly need a shallow
relief hole to clear the large diameter pin. This can be
made with a mill cutter or simply done with a hand-held
rotary bit tool (Dremel).
The grip dimensions are:
Overall height = 2.115 inches
Width through screw hole center = 1.072 inches
Height of screw hole center from base edge = 0.878 inches
Width across right grip top = 0.955 inches
Thickness near the base = 0.215 inches
These are replicas of the factory checkered grip with
carved Ruger logo at the top. Be sure to compare the size
with your gun's existing grip panels before you order.
Stock items (medallions, screws, specials) usually ship within 10 days.
I can't promise a specific ship date, as it will vary with circumstances. If you can't wait, please don't order! I'm working as fast as possible.
Be SURE to read the TERMS of SALE page, so you KNOW what you are getting.
Credit Card Processing Center adds 3.5% to order total.