|
Ruger SBH Blank (156b)
|
|
|
Quantity in Basket:
None
Code: Ruger_156b
Price: $68.00
Shipping Weight: 0.40 pounds
|
|
This is a massive oversized set of grip blanks, which was
designed to make extended base grips for Ruger Super
Blackhawks. Then it became evident that you could use
this set to make almost any large single action grip by tracing
on the back, sawing off the surplus areas, and sanding the
blank to fit.
So, while it can be used to fit any Ruger single action
ever made, it also works with a wide range of other guns.
Just compare the measurements on your gun with those on
the listing. You can order mounting screw kits or spacers
separately.
Dimensions:
- A. Length of vertical front section = 1.13 inches
- B. Overall height = 3.82 inches
- C. Width of base = 2.66 inches
- D. Midpoint of front edge to rear edge = 2.24 inches
- E. Length of top flat = 1.38 inches
- Width across narrow part of the neck = 1.56 inches
In order to make an extended length grip, the spacer block
can be epoxy glued to one grip, and sanded to match the edges.
Then, to make the grip more secure, drill a small hole in
the spacer and a matching shallow hole in the opposite
grip. Use an 1/8 inch diameter pin, about 1/4 inch long,
and press it into one of the holes. The pin should then
snap into the other hole when the grips are installed.
the spacer can be epoxy glued to both panels, but having
one panel removable in this way makes it easier to get a
snug fit on the frame.
|
Related Item(s)
Code
|
Name
|
Price
|
Availability
|
|
Ruger_54b
|
Ruger Super BH 7-10in (54b)
|
$68.00
|
|
Ruger_117a
|
Ruger Super Blackhawk, Thin (117a)
|
$68.00
|
|
|