This is a 50th Anniversary style checkered grip with the
oval logo molded in. Be sure to check the dimensions or send
a pencil outline around your existing grips because this
grip may fit a number of different Rugers. The original to
create this mold came from a Ruger Vaquero, but there is a
wide variation in sizes of grip frames. Please note that the
size of the oval logo means that if you select a medallion,
it probably will not cover the entire logo. A 3/4-inch or
larger medallion will have to be mounted relatively far
back from the front edge of the grip, or else it would be
too close to the top and bottom edge. If you want a medallion,
you may wish to consider a different model of grip having
either the standard round logo or no logo (smooth grip).
Front vertical edge height (A): 0.85 inches
Over-all height where top flat ends (B): 3.025 inch
Width of base (C): 2.073 inch
Width from center of front edge to rear edge (D): 1.7 inch
Height of screw hole center: 1.64 inch
Front edge to screw hole center: .80 inch
Rear edge to screw hole center: .60 inch
Width of flat on top: 1 inch
Width across screw hole center: 1.4 inch
Note: the top line of the grip is not parallel to the
base line. The front corner is .025 inches higher from
the base line compared to the point where the grip
begins to curve downward.
Stock items (medallions, screws, specials) usually ship within 10 days.
I can't promise a specific ship date, as it will vary with circumstances. If you can't wait, please don't order! I'm working as fast as possible.
Be SURE to read the TERMS of SALE page, so you KNOW what you are getting.
Credit Card Processing Center adds 3.5% to order total.