|
Royal Crest 5/8-in, carved silver
|
|
|
Quantity in Basket:
None
Code: SilverCrest_med
Price: $14.00
Shipping Weight: 0.02 pounds
|
|
This is a deep-relief "carved" appearance royal shield
medallion, silver color, flat-backed to be mounted using
epoxy cement in a 5/8-inch shallow hole. Flat bottom holes
can be made with Forstner bits or flat end mills.
Usually, the medallion will look better if you allow a small
amount of the thickness to project above the grip surface,
unless the grip area is large and flat enough so that the
entire medallion will fit flush at the full circumference.
Most grip surfaces are somewhat curved in more than one
plane, so that a disk inset into that curved surface will
always project above or be sunk below the surface in one
plane. For a nicer appearance, set the highest edge at
the grip surface or slightly above, and then sand the
higher edges to blend or slope downward so the lowest
edge appears to be about the same depth as the higher
edge.
All medallions are sold in pairs, so the price you see is
for two medallions. If you order here, you get them in a
package, not installed in any grip even if ordered at the
same time. To have them installed in a grip, use the
drop-down menu to select a medallion on the same page as
you order the grip. That way I know that you want them
installed in that grip, and not just as a spare set for
some other project.
The deep relief, solid metal medallion with "pierced"
areas in the pattern is a high quality style that will
enhance the appearance of your new grip.
|
|