|
S&W N-frame Round Butt Stag, Lg.
|
|
|
Quantity in Basket:
None
Code: SW_44H
Price: $75.00
Shipping Weight: 0.25 pounds
|
|
This is a grip for the Smith & Wesson "N" frame with rounded butt, in a staghorn pattern. This is one of the largest round butt "N" frame grips, slightly larger than the SW_44I smooth grip. It is normally sent with a No.4 screw kit installed, but you can order the grips without screw hole to use your own hardware (the grip kit would be sent uninstalled in that case).
Be sure to send a tracing of your grip frame or grip, as described on the "make a tracing" page. Below are the dimensions to compare with your gun frame. If your frame is larger in any dimension, this grip kit won't fit. If it is smaller, you can always send the grip to fit.
- Width across the top from ear to ear = 1.26-in (A).
- Width at narrow part of the neck = 1.26-in (not labeled on diagram).
- Width across grip at 1.3-inches from base = 1.55 inches (G).
- Width across grip at widest part of lower half = 1.6 inche (not labeled on diagram).
- Width across base just above corner radius = 1.42 inches.
- Width of flat base section = 1.3 inche (C).
- Height from base to front ear, 90-deg. to base = 2.4 inches (D).
- Height from base to rear ear, 90-deg to base = 3.2 inches (E).
- Width of front top step = 0.15 inches (H).
- Width of rear top step = 0.20 inches (I).
- Height of center of round top above line joining both ears = 0.35 inches.
- Thickness at top center = 0.21 inches.
- Thickness at base center = 0.48 inches
|
Related Item(s)
Code
|
Name
|
Price
|
Availability
|
|
SW_113a
|
S&W N-frame Rnd Butt Smooth (113a)
|
$68.00
|
|
SW_44I
|
S&W N-frame Rnd Butt Smooth, Lg.
|
$68.00
|
|
|