Nagant Smooth Large (138e)
Quantity in Basket:
Shipping Weight: 0.40 pounds
This is a larger than standard size, smooth set of grips
for the 1895 Nagant gas-seal revolver. The grips are both
thicker than the originals, and a little longer and wider.
You can sand them to same as original size but keep the
additional thickness for a more comfortable grip, or use
them full size to help cover rust marks or pitting next to
the original wood grip outline.
This is a kit, which may require some fitting and adjustment
of the spacer thickness or slight elongation of the spacer
hole so you can adjust for tolerance variations in frame
length. It comes with two mounting screws for the grip
panels themselves, and uses the original screw to secure
the spacer to the sideplate.
There are three pieces (left and right grips plus spacer)
and two screws provided.
Here are the grip dimensions:
Please note: if you would like to have medallions
installed over the mounting nut holes, please say so in
the note section. The nuts would need to be mounted deep
enough to allow some screw end clearance. If you want
them mounted in the upper curved section, you can either
send a tracing and mark the area you wish to use, or just indicate
the location in the note section above.
- Overall height of grip panels = 2.86 inches
- Width across base = 1.23 inches
- Width across screw hole = 1.25 inches
- Width below top curve = 1.16 inches
- Height of screw hole from base = 1.45 inches
- Thickness near base = 0.48 inches
- Thickness near screw hole = 0.41 inches
Nagant 1895 Checkered, 1917 (138b)