|
Colt Police Pos.Spec. Extended (17d)
|
|
|
Quantity in Basket:
None
Code: Colt_17d
Price: $68.00
Shipping Weight: 0.25 pounds
|
|
This is another variation of the Colt Police Positive Special
with square butt, this time with a 1.9-inch wide flat base
extended below the approximately 1.68-inch wide frame of
the gun with a 0.7 inch high spacer.
The grip measurements are:
- Overall height to base (B) = 3.1 inches
- Width across base (C) = 1.9 inches
- Width across top (A) = 1.0 inches
- Height of top curve (D) = 0.3 inches
- Width across screw hole (F) = 1.4 inches
- Screw hole center to front edge = 0.55 inches
- Height to front top "corner" (G) = 2.5 inches
- Base of gun frame to grip base = 0.7 inches
- Height from base to screw hole center (E) = 1.4 inches
This grip is slightly oversized so you can sand it to
exact fit before fitting the spacer and using epoxy
cement to secure the spacer to one grip panel. The
spacer has two screw holes which can be used to fasten
the spacer to one panel either instead of epoxy glue or
in addition. Or two small dowel or roll pins can be
mounted in the spacer and shallow holes made to match
in the opposing grip back, so that the spacer and both
grip panels can be removed and reassembled with a rigid
and secure position. Small pins are provided, in case
you wish to make appropriate matching holes and use them
for additional strength. However, epoxy glue of the
standard 5-minute two-part mix variety, which can be found
at any hardware store, usually works just fine provided
you clean the mating surfaces well to remove all grease, wax,
and fingerprints, and follow directions for mixing the
cement.
This is a rather easy kit to fit and finish, but it does
require sanding the grip edges and space to "blend" them
once you have the grip panels fitted to the gun frame
and the locating pin hole drilled to match the pin
projecting from your gun frame (it may vary slightly
from one gun to another -- mark the tip with "magic
Marker" ink, and press the grip panel to the gun to
transfer a "dot", indicating where to make the alignment
pin hole.
|
Related Item(s)
Code
|
Name
|
Price
|
Availability
|
|
Colt_20d
|
Colt Police Positive Special (20d)
|
$68.00
|
|
Colt_130c
|
Colt Police Pos. Spl. Smooth (130c)
|
$68.00
|
|
|