Beretta Laramie (copy of S&W Schoefield No.3) Revolver
without logo or cartouche (smooth surfaces).
You can order with or without screws installed.
Please refer to the size chart and compare to your gun
before ordering! Not all copies use the same grip
dimensions even if they claim to be copies of this
famous Smith and Wesson revolver. If your gun grip is
smaller or the same, these should work fine.
If your gun grip frame is larger, then these grips
"A" = 1-13/16"
""B" = 1-11/16"
""C" = 3-3/16"
""D" = 1-1/4"
"Width across points at the top = 1-1/4 inch
"Width of each step at the top = 3/16 inch
"Width across the rounded top's base = 7/8-inch
"Height of screw hole center from base = 1-1/2 inch
"Distance from rear edge to center of hole. measured parallel to base = 11/16 inch
"Distance to inside sharp point measured 90-degrees from base line = 2-3/8 inches
"Width across the flat on the base = 1-1/4 inch
"Width across base about 1/8 inch higher than base = 1-3/8 inch
Please Note: I make all the grips by hand and receive so many orders that custom made grip delivery takes an average 3-4 months.
Stock items (medallions, screws, specials) usually ship within 10 days.
I can't promise a specific ship date, as it will vary with circumstances. If you can't wait, please don't order! I'm working as fast as possible.
Be SURE to read the TERMS of SALE page, so you KNOW what you are getting.
Always compare listed measurements OR send a tracing of original grip or gun frame.
Do NOT order
just by description, since the same model and make can vary in actual size and shape of grip frame! Do NOT send your original grips or gun!